powder compact
英 [ˈpaʊdə(r) kəmˈpækt]
美 [ˈpaʊdər ˈkɑːmpækt]
网络 粉盒; 粉饼; 粉末压坯; 粉饼盒; 粉末压块
英英释义
noun
- a small cosmetics case with a mirror
双语例句
- The results show that the main factor affecting powder flowability is the aggregation of powder particles while the powders are in incompact state and the friction between the powder particles while the powders are in compact state.
结果表明：影响松装状态磁粉流动性的主要因素是粉末颗粒团聚，影响密实磁粉流动性的主要因素是颗粒间的摩擦力。 - Aluminum foams were fabricated by Powder Compact Foaming ( PCF) process.
采用粉末致密化发泡（PCF）工艺制备了泡沫纯铝，对制备过程及影响孔结构的因素进行了分析。 - The characteristics of metal powder compact, which provide the viability of microwave sintering, are comprehensively summarized. Electron's movement behavior in electric-agnetic field is analyzed and eddy loss is stated to be one of the mechanisms of microwave sintering.
在此基础上，总结了金属粉末压坯的特点，阐述了微波烧结金属粉末压坯的可行性，分析了自由电子在电磁场中的运动行为，指出涡流损耗是微波促进烧结的机理之一。 - The lady opened her handbag and took out her powder compact.
那位妇女打开了手提包，拿出了粉盒。 - The results of theoretic analysis show that increase the thermal conductivity of powder can effectively improve the performance of compact.
理论分析结果表明，提高粉末的热传导率能够有效提高压坯各个性能。 - Effect of morphology and particle size distribution of tungsten powder on compacting performance and green compact strength
钨粉形貌与粒度分布对成形性和压坯强度的影响 - The yield criterion of powder compact
粉末体的屈服准则 - Effect of adsorption on diffusion coefficient of polyvinyl alcohol in alumina powder compact
分子吸附对聚乙烯醇在氧化铝粉末压缩体中扩散系数的影响 - The infiltration parameters of CuW pseudobinary alloy were studied through theoretic deduction and experimental study. A formula was given out to show the relationship among infiltration time and tungsten powder size, pore fraction and CuW compact height.
通过对CuW假两相合金的熔渗参数的理论分析和实验研究，给出了熔渗时间与钨粉粒径、压坯孔隙率、压坯高度之间的定量关系式。 - In order to solve the heating method of the powder warm compact, this paper presents a heating mode with an electrical heater element by theoretical analysis and calculation, and designs a mold heating equipment.
为解决粉末温压设备的加热问题，本文通过理论分析和计算采用电加热方式，根据实际需要设计并选择合理可行的模具加热装置。